Advertising

Heat & Glo • 6000TV-OAK, 6000TV-OAK-IPI • 384-900 Rev. N • 11/05

View and Download Heat & Glo 6000TV-OAK owner's manual online. Installation and Operation. 6000TV-OAK Indoor Fireplace pdf manual download. Also for: 6000tv-oak-ipi.
View and Download Heat & Glo 6000TV-OAK owner's manual online. Vented Gas Fireplace. Heat & Glo 6000TV-OAK Indoor Fireplace pdf manual download. Also for: 6000tv-oak-ipi.
Heat-n-glo 6000 Tv Manual See the venting section 3.1 of this manual. The control system for Model 6000TV is a millivolt type. Be voided by, and Heat-N-Glo Fireplace Products, Inc. Fireplace 6000TR-OAK.

Heat & Glo LifeStyle CFL-18NG-B Manuals & User Guides. User Manuals, Guides and Specifications for your Heat & Glo LifeStyle CFL-18NG-B Indoor Fireplace. Database contains 1 Heat & Glo LifeStyle CFL-18NG-B Manuals (available for free online viewing or downloading in PDF): Installation and operation instructions manual. Heat & Glo. 6000TV-OAK, 6000TV-OAK-IPI. 384-900 Rev. Getting Started. Introducing the Heat & Glo Gas Fireplaces. Heat & Glo B-type vent gas fireplaces are designed to op-erate with all exhaust gases expelled to the outside of the building.The information contained in this Installers Guide, unless noted otherwise, applies to all models and gas control systems.

Installing the Fireplace

Heat N Glo Fireplace Instructions

Step 1. Locating the Fireplace

The diagram shows space and clearance requirements for
locating a fireplace within a room.

42”

22”

36”

51”

72”

Minimum Clearances

from the Fireplace to Combustible Materials

Inches

Glass Front ........................ 36 .................... 914
Floor ................................... 0 ....................... 0
Rear ................................... 1/2 ..................... 13
Sides ................................. 1/2 ..................... 13
Top ................................... 3 1/2 ................... 89
Ceiling* .............................. 31 .................... 787

Figure 2. Fireplace Dimensions, Locations,
and Space Requirements

Minimum Clearances from the B-Type Vent Pipe to
Combustible Materials is 1 inch (25mm) all around the
pipe.

* The clearance to the ceiling is measured from the top

of the unit, excluding the standoffs (see Figure 13).

Clearance Requirements

The top, back, and sides of the fireplace are defined by
stand-offs. The minimum clearance to a perpendicular wall
extending past the face of the fireplace is one inch (25
mm). The back of the fireplace may be recessed 21 1/2
inches (546 mm) into combustible construction.

The minimum clearance from the top face of the fireplace to
combustible finishing materials such as drywall, is one inch
(25mm).

Constructing the Chase

A chase is a vertical box-like structure built to enclose the
gas fireplace and/or its vent system. Vertical vents that run
on the outside of a building may be, but are not required to
be, installed inside a chase.

Heat N Glo Fireplace

CAUTION: TREATMENT OF FIRESTOP SPACERS AND
CONSTRUCTION OF THE CHASE MAY VARY WITH THE
TYPE OF BUILDING. THESE INSTRUCTIONS ARE NOT
SUBSTITUTES FOR THE REQUIREMENTS OF LOCAL
BUILDING CODES. THEREFORE, YOUR LOCAL BUILD-
ING CODES MUST BE CHECKED TO DETERMINE THE
REQUIREMENTS FOR THESE STEPS.

Factory-built fireplace chases should be constructed in the
manner of all outside walls of the home to prevent cold air
drafting problems. The chase should not break the outside
building envelope in any manner.

This means that the walls, ceiling, base plate and cantilever
floor of the chase should be insulated. Vapor and air infiltra-
tion barriers should be installed in the chase as per regional
codes for the rest of the home. Additionally, in regions where
cold air infiltration may be an issue, the inside surfaces
may be sheetrocked and taped for maximum air tightness.

To further prevent drafts, the firestops should be caulked
with high temperature caulk to seal gaps. Gas line holes
and other openings should be caulked with high temp caulk
or stuffed with unfaced insulation. If the appliance is being
installed on a cement slab, a layer of plywood may be placed
underneath to prevent conducting cold up into the room.

Heat And Glo Owner's Manual

THE CHASE SHOULD BE CONSTRUCTED SO THAT ALL
CLEARANCES TO THE FIREPLACE ARE MAINTAINED
AS SPECIFIED WITHIN THIS INSTALLERS GUIDE.

The distance from the unit to combustible construc-
tion is to be measured from the unit outer wrap sur-
face to the combustible construction, NOT from the
screw heads that secure the unit together.

Advertising

This manual is related to the following products:

Heat Glo Remote Control Manual

Popular Brands

Heat N Glo Troubleshooting

Popular manuals

6000tv-oak Heat & Glo Users Manual